Hitachi Compute Blade 500 Series Web Console Users Manual page 152

If applying it, clear the check mark. In SMP configuration, apply the Default
Gateway on the primary server blade. You can apply it on a non-primary
server blade, but that setting value is not used for operation. See Hitachi
Compute Blade 500 Series Management Module Setup Guide for details.
Note:
• When the default account (operator, no password) of the IP address of
Hitachi 1 Gb/sec LAN switch module (20-port, 40-port) and Hitachi 1/10
Gb/sec LAN switch module is deleted (both of LAN switch module version
is "EBS V10.7.1 or earlier" or "EBS V11.6"), set the switch module
authentication information (account, password, and administrator
password) through the console of management module. If you do not set
the switch module authentication information, IP address setting will fail.
• Do not change the IP address of Brocade 10 Gb/sec DCB switch module,
Brocade 8 Gb/sec fibre channel switch module, and Brocade 16 Gb/sec
fibre channel switch module through the switch module console. When
you change the IP address, the new one is available immediately after the
change. The new IP address is, however, overwritten by values set from
the management module when restarting the switch module or powering
on or off.
• When a value other than 0.0.0.0 is set as the default gateway of Hitachi 1
Gb LAN switch module (20-port, 40-port) and Hitachi 1/10 Gb LAN switch
module, the setting value will be added after all default gateways without
interface specified are deleted. If you need to have the default gateway
specified to VLAN ID, set the default gateway with VLAN ID specified. If
you need to set multi-path, specify 0.0.0.0 to the default gateway, then
directly log in to the LAN switch module console, and set the default
gateway.
• When you change the default gateway of Hitachi 1 Gb LAN switch module
(20-port, 40-port) and Hitachi 1/10 Gb LAN switch module to a value
other than 0.0.0.0 and then return it to 0.0.0.0 or change the switch
module connection type to other than Management LAN, the management
module does not delete the default gateway setting. Thus, you need to
directly log in to the LAN switch module console to delete the default
gateway setting.
• If unchecking "Not apply this Default Gateway setting to the LAN switch
module" and changing the Default Gateway setting to 0.0.0.0, it is not
applied. Directly log in to the LAN switch module console to set the
Default Gateway.
• When the management module firmware version is A0125 or earlier at
the factory, "Not apply this Default Gateway setting to the LAN switch
module" is checked. Updating the management module firmware does not
change the setting. When you keep "Not apply this Default Gateway
setting to the LAN switch module" checked, directly log in to the LAN
switch module to set the Default Gateway.
• When Network OS version 3.0.0 runs on a Brocade 10 Gb DCB switch
module, the default gateway setting from the management module does
not take effect on the DCB switch module. Log into the DCB switch
module and configure it using the ip route command. Refer to Network
2-142
Operating the Web Console
Hitachi Compute Blade 500 Series Web Console User's Guide