Hitachi Compute Blade 500 Series Web Console Users Manual page 137

Item
Time Edits Time zone name and Time offset from UTC.
NTP Server Edits NTP servers: IP address; NTP Version number; Authentication
key: Preference.
Spanning Tree Enable or Disable Spanning Tree.
VLAN Adds and deletes VLAN; and edits VLAN interface.
Link Aggregation Edits link aggregation, VLAN, spanning tree (PortFast), and uplink
failover.
Ether port To the Ether port, sets SNMP trap prevention, VLAN, spanning tree
(PortFast), uplink failover, link aggregation.
Uplink Failover Edits Uplink Failover mode.
IPv4 Static Route Edits IPv4 static routes.
Shows and edits only the default gateway. Even if multiple default
gateways have been set from switch module console, only the
youngest IP address of gateways is shown on Web console. If you edit
this setting in this state, all the default gateways will change to the
new value.
Log Output Edits a destination to transfer logs.
Terminal Console Edits the number of terminal consoles that can log in at a time.
Save Settings Saves the new settings in the startup configuration file.
Operating the Web Console
Hitachi Compute Blade 500 Series Web Console User's Guide
Table 2-142 Settings items
Description
2-127