Hitachi Compute Blade 500 Series Web Console Users Manual page 127

Table 2-130 Items in Boot order settings
Item
Update boot device information
button
LPAR Boot Priority
1
order
Device type
Status
Name
Slot
Controller
number
Scheduling
mode
Port
WWN/MAC
LUN
Move selection
up button
Move selection
down button
Delete from
boot order
button
USB / HBA / Device type
2
PXE tab
Registered
Status
Operating the Web Console
Hitachi Compute Blade 500 Series Web Console User's Guide
Description
Gets the boot device information again, and
update the dialog box.
When getting the information, it may take
several minutes to complete due to activate and
deactivate LPAR.
Shows the priority level.
Shows the boot device type.
Shows the boot device status.
Shows the boot device name.
Shows the card type that connects to the boot
device.
[Management module firmware version A0240 or
later]
Shows the controller number that connects
to the boot device.
[Management module firmware version A0240 or
later]
Shows the scheduling mode that connects to
the boot device.
Shows the port number that connects to the boot
device.
Shows WWN or MAC address that is assigned the
port.
Shows the LU number to use as the boot device.
Move up the order of selected boot device.
Move down the order of selected boot device.
Deleted the selected boot device from the boot
order.
Shows the device type.
Shows the boot order select or not.
Shows the assign status of logical port or device.
Assigned: The USB device is assigned. (USB)
---- -: The information cannot be taken due to
the dedicated mode. (HBA, PXE)
Available: Operate normally.(HBA)
ConfigCheck: Cannot be used due to a
configuration problem. (HBA)
2-117