Hitachi Compute Blade 500 Series Web Console Users Manual page 136

LID
Firmware version
Date
Time
Item
LID ON
LID OFF
Power ON
Power OFF
Power ON
with diagnosis
Settings tab
For Hitachi 1 Gb LAN switch module (20 ports and 40 ports); Hitachi 1/10 Gb
LAN switch module:
2-126
Item
Table 2-141 Action buttons at the bottom
Turns on the LID (Identification LED) of the selected switch module.
Turns off the LID (Identification LED) of the selected switch module.
Powers on the selected switch module.
Powers off the selected switch module.
Powers on some switch module with a specified type of diagnosis only for
maintenance work. No need to perform this item usually. This item is not
displayed when using Hitachi 1Gb LAN switch module and Hitachi 1Gb/
10Gb LAN switch module.
Shown only for Brocade 10 Gb DCB switch module, Brocade 8 Gb fibre
channel switch module, or Brocade 16 Gb fibre channel switch module.
Diagnosis types are as follows:
Extended: Performs more diagnostics in detail than normal power on. It
takes about several minutes until the switch module has completely
started up.
Full: Performs all diagnostics. It takes about 15 minutes until the switch
module has completely started up.
Operating the Web Console
Hitachi Compute Blade 500 Series Web Console User's Guide
Description
port managed by the management module is not
available while the maintenance IP address is set.
Shows an LID (Identification LED) state.
ON: Turned on.
OFF: Turned off.
-----: No switch module is installed.
Shows the switch module firmware version with up to four
digits. For firmware version with 5 or more digits, find it
on the switch module console.
Shows the date that the switch module clock recognizes.
This field shows value only when Hitachi 1Gb LAN switch
module (20-port/40-port) or Hitachi 1/10Gb LAN switch
module installed.
Shows the time that the switch module clock recognizes.
This field shows value only when Hitachi 1Gb LAN switch
module (20-port/40-port) or Hitachi 1/10Gb LAN switch
module installed.
Description