Hitachi Compute Blade 500 Series Web Console Users Manual page 116

Note:
1
.
2
.
Activate
Boot order
settings
Modify LPAR
Close
• Modify LPAR
2-106
Item
NIC Number Shows a card type, controller number, scheduling
USB Number [Management module firmware version A0205 or
Boot Mode
Shows the LPAR status.
Shows the LPAR settings.
Table 2-115 Action button at the bottom
Item
[Management module firmware version A0125 or later]
Activates the LPAR: Shows the confirmation dialog box. This button is
available when the LPAR is deactivated: LPAR state is DEACT.
[Management module firmware version A0125 or later]
Shows LPAR boot order dialog box. This button is available when the
LPAR is deactivated: LPAR state is DEACT.
Modifies LPAR settings. This button is available when the LPAR is
deactivated: LPAR state is DEACT.
Closes the LPAR Information dialog box.
Operating the Web Console
Hitachi Compute Blade 500 Series Web Console User's Guide
Description
Shows the number of a server blade in which the card
is installed and the card type in SMP configuration.
Shows boot settings for the HBA port by clicking
Enable or Disable for the boot function.
mode, port number, segment number, virtual NIC
number, and MAC address.
[Management module firmware version A0205 or
later]
Shows the number of a server blade in which the card
is installed and the card type in SMP configuration.
later]
Shows the port type and operation status.
Shows the number of a server blade in which USB is
installed and the port type in SMP configuration.
[Management module firmware version A0205 or
later]
Shows the boot mode for the LPAR.
Description