Test Call (Tc) Commands - AudioCodes Mediant 3000 User Manual

User's Manual
Ping statistics for 10.31.2.10:
Packets:Sent = 4, Received = 4, Lost 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 0ms, Maximum = 0ms, Average = 0ms
8.4.4

Test Call (TC) Commands

The Test Call commands can be used to simulate an IP-to-Tel call.
Note:
Command Short Format
/SIP/TestCall /sip/tc
Sub-Command
set dest
<number>
set src
<number>
set cid <display string>
set DTMFs <DTMF pattern>
display -
connect
<destination
number> <source
number> <caller
ID> <time>
Example:
/SIP>tc
TestCall - TC
Manage Test Tel-Link Call.
Usage:
TC set dest <number>
TC set src
TC set cid
TC set DTMFs
TC display
TC connect [dest-number] [src number] [CID] [time]
/SIP>tc display
Test Call configuration
Dest number: 402
Version 7.0
Only one test call can be activated at a given time.
Table 8-4: Test Call Command
set dest | set src | set cid | set DTMFs | display | connect
Table 8-5: Sub-Commands of Test (TC) Command
Arguments
Sets the Destination Number for the test call.
Sets the Source Number for the test call.
Sets the Display Name for the test call.
Sets the pattern of DTMFs that is played to the Tel side after
the test call is connected.
Displays all the set parameters for the test call. These values
can be manually set using the set commands or defaults.
Generates the test call toward the Tel side using the set
parameters. If no arguments are defined in the connect
command line, the test call uses the values defined using the
set commands (or defaults).
Note: There is no option for defining only the <time> value
without specifying all the other arguments that appear before
it.
<number>
<display string>
<dtmf string>
Sub-Commands
Description
103
8. CLI-Based Management
Mediant 3000