Table of Contents
Advertisement
Reference Manual
00809-0100-2230, Rev CA
4.6.1
Variables
In the Select Variables menu
options are available:
Tank Pos 1-10
Tk Pos 1, 2, 3... lets you configure variables individually for each tank
For a list of available variables see
Select Variables menu
The Select Variables menu allows you to select variables to be displayed in View Mode. Option "Tank Pos
1-10" can be used to specify a common set of variables to be used for all tanks connected to the same
2410 Tank Hub. In addition to this you can configure tanks individually by specifying a unique set of
variables for each tank. Note that the individual configuration will be added to the configuration that is
common for all tanks.
For a list of selectable variables, see
To select variables:
1. In View Mode, press <Menu> <Options> <Variables>.
2. Use the up and down arrow softkeys to navigate to the desired Tank Position item.
3. Press the OK softkey to continue to the Selected Variables list.
4. In the Select Variables list, choose the variables you wish to show in View Mode.
5. When finished, press OK to return to View Mode.
1.
Not available in Foundation fieldbus systems
2.
Tank Position refers to the position in the tank database of the Rosemount 2410 Tank Hub
Configuration and Operation
(1)
, you can choose which variables to present in View Mode. The following
(2)
lets you configure a common set of variables to be presented for all tanks
Table 4-1 on page
Table 4-1 on page
Configuration and Operation
46.
46.
July 2017
45
Advertisement
Table of Contents
