Table of Contents
Advertisement
™
F
Fieldbus Block Information
OUNDATION
July 2017
C.3
Main transducer block
The Main Transducer (TB1100) block contains parameters for configuration of the Rosemount 2230
Graphical Field Display. It contains device information including diagnostics and the ability to configure,
set to factory defaults and restart the 2230 Display.
Table C-4. Main Transducer Block parameters
Index
Number
130
Parameter
1
ST_REV
2
TAG_DESC
3
STRATEGY
4
ALERT_KEY
5
MODE_BLK
6
BLOCK_ERR
7
UPDATE_EVT
8
BLOCK_ALM
9
TRANSDUCER_DIRECTORY
10
TRANSDUCER_TYPE
11
TRANSDUCER_TYPE_VER
12
XD_ERROR
13
COLLECTION_DIRECTORY
14
HOUSING_TEMPERATURE
15
HOUSING_TEMP_UNIT
16
ENV_DEVICE_MODE
17
DIAGN_DEVICE_ALERT
18
DEVICE_VERSION_NUMBER
19
DIAGN_REVISION
20
SERIAL_NO
21
STATS_ATTEMPTS
Description
The revision level of the static data associated with the function
block. The revision value increments each time a static
parameter value itn the block is changed.
The user description of the intended application of the block.
The strategy field can be used to identify grouping of blocks.
This data is not checked or processed by the block.
The identification number of the plant unit. This information
may be used in the host for sorting alarms, etc.
The actual, target, permitted, and normal modes of the block.
Target: The mode to "go to"
Actual: The mode the "block is currently in"
Permitted: Allowed modes that target may take on
Normal: Most common mode for target
This parameter reflects the error status associated with the
hardware or software components associated with a block. It is
a bit string, so that multiple errors may be shown.
This alert is generated by any change to the static data.
The 2230 transducer block does not support update of
BLOCK_ALM information, and it does not publish BLOCK_ALM
on segment/FF bus.
Directory that specifies the number and starting indices of the
transducers in the transducer block.
Identifies the transducer.
A transducer block alarm subcode. Provides additional error
codes related to transducer blocks.
A directory that specifies the number, starting indices, and DD
Item ID's of the data collections in each transducer within a
transducer block.
Temperature inside device housing
Measurement unit for temperature
Restart/Reset Device to factory default
Tank Hub diagnostic information, see
Device software version number
Internal revision number
Main Label Device ID (serial number)
Internal communication attempts
Reference Manual
00809-0100-2230, Rev CA
Table C-5 on page
132.
™
F
Fieldbus Block Information
OUNDATION
Advertisement
Table of Contents
