Starting And Stopping Energy Measurements; Resetting The Energy Measurement; Screen Snapshots - AEMC PowerPad III 8336 User Manual

5.6.5 STARTING AND STOPPING ENERGY MEASUREMENTS

To start a measurement:
1. Press the
button while in an energy display (
starts will appear in the upper left corner of the screen, and the
metering is in progress.
2. To stop the measurement, press the
upper right corner of the screen. The
3. To resume metering, press the
NOTE: If no recording is in progress, disconnecting the energy metering results in the appearance of the blinking
icon in the status bar (in place of the

5.6.6 RESETTING THE ENERGY MEASUREMENT

To reset the measurement, press the press the
confirm. All energy values (consumed and generated) are reset.

5.7 SCREEN SNAPSHOTS

The button enables you to take up to 50 screen snapshots and display the recorded snapshots. Saved screens can
then be downloaded to a PC using DataView.
Press the button for approximately three seconds to shoot any screen displayed on the instrument. When a screen
snapshot is taken, the icon of the active mode (
replaced by the icon. You can then release the
want to record a 51st screen, the instrument informs you that snapshots must be deleted by displaying the
place of .
Item Function
1 Available image memory. Black represents memory used.
2 List of saved snapshots. Each icon represents the type of screen recorded. It is followed by the date and time of the screen snapshot.
3 Icons for browsing through the screen pages.
4
Displays a list of snapshots.
NOTE: These screens can be downloaded to a computer using DataView
Power Quality Analyzer PowerPad
button. The date and time at which the measuring stops will appear in the
icon is also replaced by the by
button again.
icon).
button to stop metering. Then press the
1
2
3
III Model 8336
®
, or Wh...). The date and time at which the measuring
,
icon on the screen blinks to indicate that energy
, , , , , ,
button. The instrument can record only 50 screen snapshots. If you
Figure 5-72
icon.
button, and then
) in the top strip of the display unit is
4
®
to
icon in
91