On/Off Button; Display - AEMC PowerPad III 8336 User Manual

2.6 ON/OFF BUTTON

The Model 8336 can operate on either battery or on AC power. Pressing the
the instrument is shut OFF suddenly (line power outage in the absence of the battery) or automatically (battery low), an
information message is displayed when it is next started up.
Pressing the button again turns the instrument OFF. If the instrument is recording, metering energy, or searching for
transients, alarms, and/or inrush current acquisition, it requests confirmation.
Select YES or NO on the corresponding yellow buttons, then press the
● If NO is selected, recording will continue.
● If YES is selected, the data recorded until that point are finalized and the instrument is turned OFF.

2.7 DISPLAY

The backlit 320x240-pixel (1/4 VGA) graphic TFT screen displays all measurements with their graphs, the parameters of
the unit, the graphs selected, the instantaneous values of the signals, and the type of measurement selected. When the
instrument is powered up, it automatically displays the Waveform screen.
1. Top bar on the display, including:
● Symbol of the tested mode (
● Frequency of measured signal
● Memory capacity status bar (only available in certain modes)
● Current date and time
● Battery charge status (see § 2.9)
2. Measured RMS values associated with waveforms.
12
1
2
3
, , , etc.)
button to confirm.
02/06/14
4
Figure 2-2
button powers up the instrument. If
5
Power Quality Analyzer PowerPad III Model 8336
®