Starting And Stopping Energy Measurements; Resetting The Energy Measurement; Snapshot Mode; Opening A Previously Saved Snapshot - AEMC PowerPad 8435 User Manual

4.6.4 STARTING AND STOPPING ENERGY MEASUREMENTS

To start a measurement:
1. Press the button while in an energy display (
starts will appear in the upper left corner of the screen, and the
metering is in progress.
2. To stop the measurement, press the
upper right corner of the screen. The
3. To resume metering, press the
NOTE: If no recording is in progress, disconnecting the energy metering results in the appearance of the blinking
status bar (in place of the

4.6.5 RESETTING THE ENERGY MEASUREMENT

To reset the measurement, press the press the
confirm. All energy values (consumed and generated) are reset.

4.7 SNAPSHOT MODE

This button allows 50 snapshots to be saved for future recall and evaluation.
■ Press the
button (for about 3s) to capture the current display.
■ The icon is displayed in the top left corner as soon as the operation is successful.
■ This icon is replaced by
■ The snapshot will record all measurements present at the input of the meter when you press the
These screens can be downloaded to a computer using DataView

4.7.1 OPENING A PREVIOUSLY SAVED SNAPSHOT

■ A short press (about 1s) on the
■ The small icon to the left of each snapshot (date and time) tells you what type of data was stored.
Power Quality Analyzer PowerPad
Find Quality Products Online at:
button. The date and time at which the measuring stops will appear in the
icon is also replaced by the by
button again.
icon).
button to stop metering. Then press the
if there is no space left in the memory to record the display.
button gives access to the menu of snapshots that have been saved.
® III Model 8435
GlobalTestSupply
www.
, , or Wh...). The date and time at which the measuring
icon on the screen blinks to indicate that energy
icon.
®
02/06/14
Figure 4-47
.com
icon in the
button, and then to
button.
sales@GlobalTestSupply.com
71