Displaying A Transient - AEMC PowerPad III 8336 User Manual

After you program the search, start it by pressing the
search is underway. While the search is active, the
before it is finished.
The message "Detection on standby" is displayed until the start time of the search is reached. When the search starts,
this message is replaced by the message "Detection in progress." When the stop time is reached, the Detection schedule
menu returns with the
stop date field can be modified. It is automatically highlighted in yellow.
To return to the Waveform capture screen, press

5.1.1.2 DISPLAYING A TRANSIENT

To display the recorded transient, proceed as follows:
To display the recorded transients, press
Item Function
1 The displayed value indicates the page number and the number of pages.
These icons let you browse through the previous and next screens. Press the yellow buttons corresponding to these icons to display
2
the pages.
If the stop date is in red, it means that it does not match the stop date initially programmed, because either:
● There is a power supply problem (battery low or disconnection from AC power)
● The number of transients has been reached, thereby ending the search
To select a search for transients, move the cursor to it using the ▲ and ▼ buttons. The selected search is bolded. Confirm
by pressing . The screen then displays a list of transients.
42
button displayed. You can now program another search. During a search for transients, only the
button. The Detection List screen is displayed.
button. The icon on the status bar blinks to indicate that the
button replaces the button and can be used to stop the search
.
Figure 5-3
Power Quality Analyzer PowerPad III Model 8336
®