Transient Current Thresholds - AEMC PowerPad III 8336 User Manual

4.1.6.2 TRANSIENT CURRENT THRESHOLDS

A second Thresholds screen, displayed by pressing the A icon, configure the current thresholds (independently of
the current sensors detected by the instrument). The thresholds programmed can be the same for all channels or different
for some or all of them.
To change the current thresholds, press
■ 4A: all current sensors have the same threshold.
- Press the
- Press the
■ 3A + AN: all current sensors have the same threshold and the one connected to the neutral has a different threshold.
Proceed as when there is only one ratio, but perform the operation twice.
■ A1+A2+A3+AN: each current sensor has a different threshold, to be programmed. Proceed as when there is only one
ratio, but perform the operation several times
Confirm your selections by pressing
NOTE: You cannot modify thresholds in the transient mode if the instrument is searching for transients.
32
. Use the ▲ and ▼ buttons to choose configuration of the thresholds.
button, then use the ▲ and ▼ buttons to highlight the value of the threshold in yellow.
button, then use the arrow buttons to change the threshold. The unit can be A, kA, or mA.
. To return to the Configuration menu, press
Figure 4-17
.
Power Quality Analyzer PowerPad III Model 8336
®