Installing The Battery; Charging The Battery; Setting The Language - AEMC PowerPad III 8336 User Manual

1.3 INSTALLING THE BATTERY

WARNING:
● For safety reasons, replace the battery only with the original replacement model (see § 1.2.2).
● Do not expose the battery to heat exceeding 212°F (100°C).
● Do not short-circuit the battery terminals.
● To eliminate all risk of electric shock, disconnect the power supply cord and measurement leads of the
instrument.
1. Turn the instrument over, raise the stand, and prop it up.
2. Use a coin to unscrew the two quarter-turn screws on the back of the housing.
3. Using a flat screwdriver, remove the cover from the compartment.
4. Turn the instrument over and hold the battery as it slides out of its compartment.
5. Disconnect the battery connector without pulling on the wires.
6. Connect the new battery. The connector is error-proofed to prevent reversals of
polarity.
7. Place the battery in its compartment and arrange the wires so that they do not
protrude.
8. Put the battery compartment cover back in place and screw the two screws back in.

1.4 CHARGING THE BATTERY

Fully charge the battery before the first use.
NOTE: A full recharge of a completely discharged battery takes approximately 5 hrs.
?

1.5 SETTING THE LANGUAGE

■ Before using the device, first choose the language in which
you want the device to display its message.
■ Press the green button to switch the device on.
■ Press the Configuration
■ Press the yellow button on the device corresponding to the
desired language.
8
To recharge the battery:
120V ± 10%, 60Hz
230V ± 10%, 50Hz
■ Remove the cover of the battery charging connector.
■ Connect the supplied power cord to the instrument and AC
■ The
button.
power.
button lights and will go out when the power cord is
disconnected.
Power Quality Analyzer PowerPad III Model 8336
®