Viewing The Recording List - AEMC PowerPad III 8336 User Manual

To program a recording, set the parameters listed in the Recording Schedule screen:
● Set-up identifies the configuration
● Start defines the time and date when the recording starts. The start date and time must be later than the current
date and time.
● Stop specifies when the recording ends. This must be later than the start date and time.
● Period is the time over which the measurements of each recorded value are averaged (arithmetic mean).
Allowable values are 1s, 5s, 20s, 1min, 2min, 5min, 10min, and 15min.
● Name can be up to eight characters long. Several recordings can have the same name. Allowable characters are
uppercase A through Z and the numbers 0 through 9. The last five names assigned (in the transient, trend, and
alarm modes) are kept in memory. When a name is entered, it can then be completed automatically.
To modify an item, move the yellow cursor to it using the up and down arrow buttons, then press the
the value using the arrow buttons, then press
After you finish setting the parameters, start the recording by pressing the
an error message appears informing you of this. The
NOTE: The button replaces the
The "Recording on standby" message is displayed until the start time is reached. It is then replaced by the message
"Recording running." When the stop time is reached, the Recording Schedule screen returns with the
displayed. You can then program a new recording. During the recording of a trend, only the stop date field can be
modified. It is automatically highlighted in yellow.

5.5.2 VIEWING THE RECORDING LIST

The Recording List
Item Function
1 Recording name
2 Memory usage (black indicates % of memory used)
3 Recording start time
4 Recording end time
If the stop date is in red, it does not match the stop date initially programmed because of a power supply problem (battery
low or disconnection of the instrument from AC power).
Power Quality Analyzer PowerPad
button and can be used to stop the recording before it is finished.
submenu displays the recording list already made..
1
III Model 8336
®
through .
again to confirm.
icon in the status bar blinks to indicate that recording has begun.
2 3
Figure 5-45
button. If not enough memory is available,
4
button. Change
button
75