Use; Start-Up; Configuration (Set-Up Mode); Installation Of The Leads And Current Sensors - AEMC PowerPad III 8336 User Manual

3.1 START-UP

To turn the Model 8336 ON, press the
cord is not connected to AC power. During startup, several informational screens appear, displaying data such as the
firmware version and serial number of the instrument. When startup is complete, the Waveform screen is displayed.

3.2 CONFIGURATION (SET-UP MODE)

NOTE: The instrument must be configured before each use. The configuration is saved in memory when the instru-
ment is turned OFF.
To display the Configuration screen, press the
NOTE: All configurations can also be modified through DataView

3.3 INSTALLATION OF THE LEADS AND CURRENT SENSORS

Color-coded ID markers are supplied with the PowerPad
● Detach the appropriate inserts from the color-coded marker and place them in the holes provided under the
terminals (larger inserts for current terminals, smaller inserts for voltage terminals).
● Clip the rings of the same color to the ends of the lead that will connect to the terminal.
● Connect the measurement leads to the terminals of the instrument (see § 2.8).
Power Quality Analyzer PowerPad
button. The button lights up when initially pressed; it then goes OFF if the power
III Model 8336
®

3. USE

02/06/14
Figure 3-1
button and follow the instructions in the Configuration chapter (see § 4).
software.
®
to identify the leads and input terminals.
®
Figure 3-2
15