Cabling - NEC Univerge SV8100 System Hardware Manual

Issue 1.0
S
S 5
YSTEM
ECTION
5.1
2 - 16
R
EQUIREMENTS AND

Cabling

This section provides cabling requirements and specifications for various
equipment used in the SV8100 system.
Figure 2-3 Connecting the DLC Using Twisted 2-Pair Cable
chassis connected with each of the multiline terminals and single line
telephones by a separate twisted 1-pair cable or 2-pair cable (only for Multiline
Terminals).
DLC
Figure 2-3 Connecting the DLC Using Twisted 2-Pair Cable
Refer to the following tables for cabling requirements and specifications.
Table 2-11 DT300 Series Loop Resistance and Cable Length
Table 2-12 DT700 Series Loop Resistance and Cable Length
term
Table 2-13 D
Length
Table 2-14 Cable Connection Between the Analog Port and the Single Line
Equipment
Table 2-15 Cabling Requirements
Table 2-11 DT300 Series Loop Resistance and Cable Length
Terminal or Adapter
DTL-2E-1 (BK) TEL
DTL-6DE-1 (BK) TEL
DTL-8LD-1 (BK) TEL
DTL-8LD-1 (WH) TEL
DTL-12BT-1 (BK) TEL
DTL-12PA-1 (BK) TEL
DTL-12D-1 (BK) TEL
DTL-12D-1 (WH) TEL
S
PECIFICATIONS
Twisted 2-Pair Cable
term
Series i or D IP Terminal Loop Resistance and Cable
By Twisted 1-Pair
Cable (without
AC Adapter)
24 AWG
1,969 ft (600m)
1,969 ft (600m)
1,969 ft (600m)
1,969 ft (600m)
1,969 ft (600m)
1,969 ft (600m)
UNIVERGE SV8100
is a diagram of the
RJ-11
Multiline Terminal
SV8100 System Specifications