NEC Univerge SV8100 System Hardware Manual page 337

UNIVERGE SV8100
System Hardware Manual
3. Install a modular jack for each PGD(2)-U10 ADP. For each module, run
one-pair 24 AWG station cable from the cross-connect block to a
modular jack. Ground the unused pair.
4. Terminate the extension leads to GRN/RED of the modular jack.
Terminate the unused leads to the jack.
5. Install bridging clips as required.
6. Plug a modular line cord from the mod jack to the CN1 connector on the
PGD(2)-U10 ADP.
7. Connect an RCA jack to the audio output(s) on the back of the
PGD(2)-U10 ADP.
8. The opposite end of this cable is connected to the external music source
either directly or by connecting to the cross-connect block where the
music source is connected.
Figure 6-16 CPRU Connections
Issue 1.0
6 - 25