Order Of Installing Trunk Blades; Installing Cd-4Cota, Cd-4Diopb, Cd-4Odta Or Cd-2Bria Blades - NEC Univerge SV8100 System Hardware Manual

Issue 1.0
4 - 6
The system automatically recognizes each blade installed in the
system. If a blade has previously been installed in a slot and another
type of blade is to be installed in that same slot, the blade must first
be removed from the chassis and then the slot definition removed
using Program 90-05 prior to installing the new blade.
This same condition applies to extensions and other devices
connected to the system. For example, if a port was previously used
for a telephone and a DSS Console is to be installed in that same
port, it must first be undefined in Program 10-03 before the console
is connected.
2.2.3

Order of Installing Trunk Blades

2.2.3.1 Installing CD-4COTA, CD-4DIOPB, CD-4ODTA or
CD-2BRIA blades
The order in which trunk blades are physically inserted
determines the numbering plan.
For example, if four blades are installed in the following
order, the numbering plan below applies.
Installation
To avoid unexpected extension/trunk
numbering if the VoIP or Voice Mail
blades register with the system first,
install these blades after the other types
of extension and trunk blades have been
installed.
Table 4-3 Trunk Blade Installation Order Example
Order of Blade Slot
Number
1 4
2 5
3 7
4 6
UNIVERGE SV8100
Blade Line Circuits
CD-4COTA with
PZ-4COTE
CD-4COTA 9~12
13~16
CD-4ODTA
CD-4ODTA 17~20
Installing the SV8100 Blades
1~8