Installation - NEC Univerge SV8100 System Hardware Manual

Issue 1.0
4 - 18
RTP Forwarding
VoCoder Conversion
3.1.2

Installation

Each SV8100 system must have the CD-CP00 installed in Slot 1
of the Controlling Chassis.
1. Install the battery on the CD-CP00. The polarity "+" symbol
must be on top as illustrated in
Installation.
IMPORTANT INSTALLATION NOTES
The chassis power must be off when installing or
removing the CD-CP00.
After removing a previously installed CD-CP00,
handle the blade, carefully, from the edges. If
certain solder points/resistors are touched on the
back of the blade, some RAM/temporary memory
may be lost (e.g., time, date, user-defined settings,
etc.)
UNIVERGE SV8100
Figure 4-5 CD-CP00 Battery
Installing the SV8100 Blades