UNIVERGE SV8100
System Hardware Manual
7.4.2
Wall Mounting the Bluetooth Cradle
To prevent possible damage to the BCH-L (BK)
UNIT due to falling, NEC recommends installing
the unit in a firm position so it will not fall due to its
own weight.
Clearances required for installing the Bluetooth cradle are shown
below. Avoid mounting the cradle on a plaster-board wall, but before
mounting the cradle on a wall, check that the wall can withstand the
weight of the telephone and the load from pulling the telephone
during operation.
Figure 5-103 Wall Mount Spacing Guide BCH-L (BK) UNIT
1.
Attach two wood screws to the wall.
Keep a clearance of about 0.08" (2mm) between each wood screw
.
and the wall (refer to
5-84).
Figure 5-104 Installing Wood Screws on page
Issue 1.0
5 - 83