NEC Univerge SV8100 System Hardware Manual page 280

Issue 1.0
5 - 62
10.
11.
12.
13.
14.
15.
16.
17.
Installing DT300/DT700 Series (DTL/ITL) Digital and IP Multiline Terminals
Open the small door covering the side option
connectors by pulling the cover latch toward you
(refer to Figure 5-72 Serial Cable
DT700 only).
Connect the cable from the DCL-60-1 CONSOLE to
the Side Option Connector on the multiline terminal
and close the cover (ITL, DT700 only).
Figure 5-72 Serial Cable Installed
Set the height of the tilt leg on the multiline terminal
to the desired height.
Set the height of the tilt leg on the DCL-60-1
CONSOLE to match the tilt leg on the multiline
terminal.
Attach the side panel to the side of the DCL-60-1
CONSOLE.
Return the multiline terminal and DCL-60-1
CONSOLE to the buttons side up position.
Connect the digital cable to the LINE jack (DT300
Series).
Connect the AC Adapter cable (DT300/DT700
Series) See Figure 5-73 Connect AC Adapter Cable
on page 5-63.
UNIVERGE SV8100
Installed, ITL,