Installation - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100
System Hardware Manual
4.4.2

Installation

These daughter boards can be installed on the CD-4LCA or
CD-8LCA blades.
To install the PZ-4LCA
1. Included with the SLIDB are four plastic spacers. Install the
plastic spacers onto either the CD-4LCA or CD-8LCA. Make
sure to attach the spacers so that they extend out on the side of
the daughter board which has the CN1 connector. Refer to
Figure 4-19 Installing the PZ-4LCA Daughter Board on page
4-50 and
on page
2. Position the SLIDB CN1 connector over the CN4 connector on
the SLIU blade. Press the boards together, ensuring the plastic
spacers lock in place. Refer to
PZ-4LCA Daughter Board on page 4-50
Installing the PZ-8LCE Daughter Board on page
3. Install the SLIU blade into the slot on the chassis.
When connecting a fax machine or analog
modem, make sure to set Program 15-03-03 to
1 (special terminal) to avoid communication
problems.
The SLIU and SLIDB are categorized as
TNV2. With this designation, off-premise
wiring is not acceptable. Any cabling to the
SLIDB PCB must be within the building – no
outside cabling is permitted.
Branch connection is not acceptable.
/ :
PZ-8LCE
Figure 4-20 Installing the PZ-8LCE Daughter Board
4-51.
Figure 4-19 Installing the
and Figure 4-20
4-51.
Issue 1.0
4 - 53