NEC Univerge SV8100 System Hardware Manual page 137

UNIVERGE SV8100
RUN (LED1)
System Hardware Manual
RUN (LED 1) = The CPU is operating (green)
LED 2, and 3 = Alarms (red)
LED 4 = Flash access indication (red)
LED 5 = The USB memory connection status (red)
(LED off when no USB memory installed)
Refer to Program 90-10: System Alarm Setup for details on assigning
alarm LEDs.
Table 4-7 CD-CP00 LED Indications on page 4-21
each LED and associated operation and status indications. Refer to
Figure 4-3 CD-CP00 Blade Layout on page 4-14
the LEDs on the CD-CP00.
LED Indication
LED2 LED3
Blinking Off
Off Off
Off On
Blinking Blinking
Off On
Off On
On Blinking Blinking Blinking On Steady When
Blinking Off
Blinking Off
Blinking Off
Table 4-7 CD-CP00 LED Indications
LED4 LED5
Off Off On Steady When
USB Memory is
Installing
Off Off Blinking
Off Off
Off Access On Steady When
Blink USB Memory is
Installing
On Access On Steady When
Blink USB Memory is
Installing
Off Access On Steady When
Blink USB Memory is
Installing
USB Memory is
Installing
Off Off
Off On On Steady When
USB Memory is
Installing
On Off On Steady When
USB Memory is
Installing
provides a list of
for the location of
Status
System operating normally
Boot is starting
Off Initializing the disk or
formatting
Boot program is initializing in
the flash memory
Reading system software
Upgrading system software
Finish formatting (SRAM,
Flash)
Off DRAM error
FPGA version error
SRAM error
Issue 1.0
4 - 21