NEC Univerge SV8100 System Hardware Manual page 270

Issue 1.0
5 - 52
3.
4.
5.
6.
Figure 5-57 Ribbon Cable Connector
7.
8.
Installing DT300/DT700 Series (DTL/ITL) Digital and IP Multiline Terminals
Remove the screw (refer to
Side Panel from Multiline Terminal on page
Carefully, return the multiline terminal to the buttons
side up position.
Remove the soft keys and line key kit from the
telephone.
Gently lift the small black bar on the ribbon cable
connector (refer to Figure 5-57 Ribbon Cable
Connector).
Plug ribbon cable on back of 8LKD (LD)-L UNIT into
connector until pressure is felt.
Press down on the black bar to lock the cable into
place (refer to Figure 5-58 Ribbon Cable Installed
on page 5-53).
UNIVERGE SV8100
Figure 5-56 Remove
5-51).
Lift
Here