ST STM32F2 User Manual page 363

UM1940
HAL_MMC_ERROR_CARD_ECC_FAILED
HAL_MMC_ERROR_CC_ERR
HAL_MMC_ERROR_GENERAL_UNKNOWN_ERR
HAL_MMC_ERROR_STREAM_READ_UNDERRUN
HAL_MMC_ERROR_STREAM_WRITE_OVERRUN
HAL_MMC_ERROR_CID_CSD_OVERWRITE
HAL_MMC_ERROR_WP_ERASE_SKIP
HAL_MMC_ERROR_CARD_ECC_DISABLED
HAL_MMC_ERROR_ERASE_RESET
HAL_MMC_ERROR_AKE_SEQ_ERR
HAL_MMC_ERROR_INVALID_VOLTRANGE
HAL_MMC_ERROR_ADDR_OUT_OF_RANGE
HAL_MMC_ERROR_REQUEST_NOT_APPLICABLE
HAL_MMC_ERROR_PARAM
HAL_MMC_ERROR_UNSUPPORTED_FEATURE
HAL_MMC_ERROR_BUSY
HAL_MMC_ERROR_DMA
HAL_MMC_ERROR_TIMEOUT
MMC context enumeration structure
MMC_CONTEXT_NONE
MMC_CONTEXT_READ_SINGLE_BLOCK
MMC_CONTEXT_READ_MULTIPLE_BLOCK
MMC_CONTEXT_WRITE_SINGLE_BLOCK
MMC_CONTEXT_WRITE_MULTIPLE_BLOCK
MMC_CONTEXT_IT
MMC_CONTEXT_DMA
MMC Voltage mode
MMC_HIGH_VOLTAGE_RANGE
None
Read single block operation
Read multiple blocks operation
Write single block operation
Write multiple blocks operation
Process in Interrupt mode
Process in DMA mode
VALUE OF ARGUMENT
DocID028236 Rev 2
HAL MMC Generic Driver
Card internal ECC was applied but
failed to correct the data
Internal card controller error
General or unknown error
The card could not sustain data
reading in stream rmode
The card could not sustain data
programming in stream mode
CID/CSD overwrite error
Only partial address space was
erased
Command has been executed
without using internal ECC
Erase sequence was cleared
before executing because an out
of erase sequence command was
received
Error in sequence of authentication
Error in case of invalid voltage
range
Error when addressed block is out
of range
Error when command request is
not applicable
the used parameter is not valid
Error when feature is not
insupported
Error when transfer process is
busy
Error while DMA transfer
Timeout error
363/1371