Initialization And De-Initialization Functions; Io Operation Functions; Peripheral Control Functions; Peripheral State And Errors Functions - ST STM32F2 User Manual

HAL DAC Generic Driver
12.2.3

Initialization and de-initialization functions

This section provides functions allowing to:
Initialize and configure the DAC.
De-initialize the DAC.
This section contains the following APIs:
HAL_DAC_Init()
HAL_DAC_DeInit()
HAL_DAC_MspInit()
HAL_DAC_MspDeInit()
12.2.4

IO operation functions

This section provides functions allowing to:
Start conversion.
Stop conversion.
Start conversion and enable DMA transfer.
Stop conversion and disable DMA transfer.
Get result of conversion.
This section contains the following APIs:
HAL_DAC_Start()
HAL_DAC_Stop()
HAL_DAC_Start_DMA()
HAL_DAC_Stop_DMA()
HAL_DAC_GetValue()
HAL_DAC_IRQHandler()
HAL_DAC_ConvCpltCallbackCh1()
HAL_DAC_ConvHalfCpltCallbackCh1()
HAL_DAC_ErrorCallbackCh1()
HAL_DAC_DMAUnderrunCallbackCh1()
12.2.5

Peripheral Control functions

This section provides functions allowing to:
Configure channels.
Set the specified data holding register value for DAC channel.
This section contains the following APIs:
HAL_DAC_ConfigChannel()
HAL_DAC_SetValue()
12.2.6

Peripheral State and Errors functions

This subsection provides functions allowing to
Check the DAC state.
Check the DAC Errors.
162/1371
You can refer to the DAC HAL driver header file for more useful macros
DocID028236 Rev 2
UM1940