ST STM32F2 User Manual page 232

HAL ETH Generic Driver
__HAL_ETH_ETH_MMC_COUNTER_RO
LLOVER_DISABLE
__HAL_ETH_MMC_COUNTERS_RESET
__HAL_ETH_MMC_RX_IT_ENABLE
__HAL_ETH_MMC_RX_IT_DISABLE
232/1371
Parameters:
Return value:
Description:
Parameters:
Return value:
Description:
Parameters:
Return value:
Description:
Parameters:
Return value:
Description:
DocID028236 Rev 2
Rollover.
__HANDLE__: ETH Handle.
None
Disables the MMC Counter Stop
Rollover.
__HANDLE__: ETH Handle.
None
Resets the MMC Counters.
__HANDLE__: ETH Handle.
None
Enables the specified ETHERNET MMC
Rx interrupts.
__HANDLE__: ETH Handle.
__INTERRUPT__: specifies the
ETHERNET MMC interrupt sources to
be enabled or disabled. This parameter
can be one of the following values:
ETH_MMC_IT_RGUF : When Rx
good unicast frames counter
reaches half the maximum value
ETH_MMC_IT_RFAE : When Rx
alignment error counter reaches
half the maximum value
ETH_MMC_IT_RFCE : When Rx
crc error counter reaches half the
maximum value
None
Disables the specified ETHERNET MMC
Rx interrupts.
UM1940