ST STM32F2 User Manual page 233
Description of stm32f2 hal and low layer drivers
Hide thumbs
Also See for STM32F2:
- User manual (108 pages) ,
- Application note (56 pages) ,
- User manual (19 pages)
Table of Contents
Advertisement
UM1940
__HAL_ETH_MMC_TX_IT_ENABLE
__HAL_ETH_MMC_TX_IT_DISABLE
Parameters:
Return value:
Description:
Parameters:
Return value:
Description:
Parameters:
DocID028236 Rev 2
HAL ETH Generic Driver
__HANDLE__: ETH Handle.
__INTERRUPT__: specifies the
ETHERNET MMC interrupt sources to
be enabled or disabled. This parameter
can be one of the following values:
ETH_MMC_IT_RGUF : When Rx
good unicast frames counter
reaches half the maximum value
ETH_MMC_IT_RFAE : When Rx
alignment error counter reaches
half the maximum value
ETH_MMC_IT_RFCE : When Rx
crc error counter reaches half the
maximum value
None
Enables the specified ETHERNET MMC
Tx interrupts.
__HANDLE__: ETH Handle.
__INTERRUPT__: specifies the
ETHERNET MMC interrupt sources to
be enabled or disabled. This parameter
can be one of the following values:
ETH_MMC_IT_TGF : When Tx
good frame counter reaches half
the maximum value
ETH_MMC_IT_TGFMSC: When Tx
good multi col counter reaches half
the maximum value
ETH_MMC_IT_TGFSC : When Tx
good single col counter reaches
half the maximum value
None
Disables the specified ETHERNET MMC
Tx interrupts.
__HANDLE__: ETH Handle.
__INTERRUPT__: specifies the
ETHERNET MMC interrupt sources to
be enabled or disabled. This parameter
can be one of the following values:
ETH_MMC_IT_TGF : When Tx
good frame counter reaches half
233/1371
Advertisement
Table of Contents
Need help?
Do you have a question about the STM32F2 and is the answer not in the manual?
Questions and answers