ST STM32F2 User Manual page 250

HAL FLASH Generic Driver
__HAL_FLASH_CLEAR_FLAG
250/1371 DocID028236 Rev 2
__FLAG__: specifies the FLASH
flags to check. This parameter
can be any combination of the
following values:
FLASH_FLAG_EOP :
FLASH End of Operation flag
FLASH_FLAG_OPERR :
FLASH operation Error flag
FLASH_FLAG_WRPERR:
FLASH Write protected error
flag
FLASH_FLAG_PGAERR:
FLASH Programming
Alignment error flag
FLASH_FLAG_PGPERR:
FLASH Programming
Parallelism error flag
FLASH_FLAG_PGSERR:
FLASH Programming
Sequence error flag
FLASH_FLAG_BSY : FLASH
Busy flag
Return value:
The: new state of __FLAG__
(SET or RESET).
Description:
Clear the specified FLASH flags.
Parameters:
__FLAG__: specifies the FLASH
flags to clear. This parameter can
be any combination of the
following values:
FLASH_FLAG_EOP :
FLASH End of Operation flag
FLASH_FLAG_OPERR :
FLASH operation Error flag
FLASH_FLAG_WRPERR:
FLASH Write protected error
flag
FLASH_FLAG_PGAERR:
FLASH Programming
Alignment error flag
FLASH_FLAG_PGPERR:
FLASH Programming
Parallelism error flag
FLASH_FLAG_PGSERR:
FLASH Programming
Sequence error flag
Return value:
none
UM1940