ST STM32F2 User Manual page 186

HAL DCMI Generic Driver
__HAL_DCMI_CLEAR_FLAG
__HAL_DCMI_ENABLE_IT
186/1371
Return value:
The: state of FLAG.
Description:
Clear the DCMI pending flags.
Parameters:
__HANDLE__: DCMI handle
__FLAG__: specifies the flag to clear.
This parameter can be any combination of
the following values:
Return value:
None
Description:
Enable the specified DCMI interrupts.
Parameters:
__HANDLE__: DCMI handle
__INTERRUPT__: specifies the DCMI
interrupt sources to be enabled. This
parameter can be any combination of the
following values:
DocID028236 Rev 2
flag mask
DCMI_FLAG_LINERI: Line flag mask
DCMI_FLAG_FRAMEMI: DCMI
Capture complete masked interrupt
status
DCMI_FLAG_OVRMI: DCMI Overrun
masked interrupt status
DCMI_FLAG_ERRMI: DCMI
Synchronization error masked
interrupt status
DCMI_FLAG_VSYNCMI: DCMI
VSYNC masked interrupt status
DCMI_FLAG_LINEMI: DCMI Line
masked interrupt status
DCMI_FLAG_FRAMERI: Frame
capture complete flag mask
DCMI_FLAG_OVRRI: Overrun flag
mask
DCMI_FLAG_ERRRI:
Synchronization error flag mask
DCMI_FLAG_VSYNCRI: VSYNC
flag mask
DCMI_FLAG_LINERI: Line flag mask
DCMI_IT_FRAME: Frame capture
complete interrupt mask
DCMI_IT_OVR: Overrun interrupt
mask
DCMI_IT_ERR: Synchronization
error interrupt mask
UM1940