Mitsubishi MELDAS MDS-C1 Instruction Manual page 99

High-gain specifications
No. Abbrev. Parameter name
SV025 MTYP* Motor/Detector type
Excessive error
SV026 OD2
detection width
during servo OFF
Parameters with an asterisk * in the abbreviation, such as PC1*, are validated with the NC power turned ON again.
3. Setup
8
Set the detector type.
9
Set the position detector type for "pen", and the speed detector type
ent
for "ent". In the case of the semi-closed loop control, set the same
A
value for "pen" and "ent".
B
pen
C
setting
D
0
pen
E
1
F
2
3
4 Setting impossible OHE25K-ET, OSE104-ET
5 Setting impossible OHA25K-ET, OSA104-ET
6 Setting impossible
7 Setting impossible
8 Setting impossible
9 Setting impossible
A Setting impossible
B Setting impossible
C
synchronization)
D
synchronization)
E Setting impossible
F Setting impossible
Set the excessive error detection width when servo ON.
For the standard setting, refer to the explanation of SV023 (OD1).
When "0" is set, the excessive error detection will not be performed.
3 - 20
Explanation
ent setting Detector model name
0 OSE104
1 OSA104
2 OSE105, OSA105
3
OSE105-ET, OSA105-ET, RCN723
(Heidenhain)
Relative position detection scale, MP type
(Mitsubishi Heavy Industries)
AT41 (Mitsutoyo), FME type, FLE type
(Futaba)
AT342, AT343 (Mitsutoyo),
LC191M/491M (Heidenhain), MDS-B-HR
C
The setting of the slave axis in the speed/current
(Current synchronization control.
When the master axis is the semi-closed control.
The setting of the slave axis in the speed/ current
E
synchronization control.
When the master axis is the full-closed control.
(Current
(Current synchronization control is only for
MDS-C1-V2.)
Setting range
(Unit)
0 to 32767
(mm)