Mitsubishi MELDAS MDS-C1 Instruction Manual page 63

(4) Connecting the encoder for C axis control
Refer to section (1) for connection with the spindle motor.
Max. 30m
U V W
Spindle motor
Supplement
1. The C axis control function is connected to the CN7 connector.
2. When using both the C axis control function and orientation function, two cables (two-wire cable) are
connected from the detector.
3. The orientation signal connected to CN5 or CN6 can be connected to the NC with the differential
output from the CN8 connector.
2. Wiring and Connection
Option cable : CNP5S
Option cable : CNP7A
Power cable
C axis control
Encoder
Option cable : CNP67A
MDS-C1-SP
CN6
CN5
CN7
U V W
Spindle
2 - 30
Connect to ENC
connector on NC side
Option cable : CNP71A