Mitsubishi MELDAS MDS-C1 Instruction Manual page 211

5-1 D/A output specifications for spindle drive unit............................................................
5-1-1 D/A output specifications .......................................................................................
5-1-2 Setting the output data ..........................................................................................
5-1-3 Setting the output magnification............................................................................
5-2 Spindle control signal ...................................................................................................
5-2-1 Spindle control input (NC to SP) ...........................................................................
5-2-2 Spindle control output
5-3 Adjustment procedures for each control......................................................................
5-3-1 Basic adjustments .................................................................................................
5-3-2 Adjusting the acceleration/deceleration operation................................................
5-3-3 Adjusting the orientation control............................................................................
5-3-4 Adjusting the synchronous tap control ..................................................................
5-3-5 Adjusting the C-axis control ..................................................................................
5-3-6 Adjusting the spindle synchronous control ...........................................................
5. Spindle Adjustment
..........................................................................
(SP to NC)
5 - 1
5-2
5-2
5-2
5-3
5-4
5-4
5-9
5-15
5-15
5-16
5-19
5-26
5-30
5-32