Mitsubishi MELDAS MDS-C1 Instruction Manual page 163

No. Abbr. Parameter name
D/A output channel 2
SP254 DA2NO
data number
DA output channel 1
SP255
DA1MPY
magnification
DA output channel 2
SP256
DA2MPY
magnification
SP257 RPM*
Motor constant
to to
(H coil)
SP320 BSD*
SP321 RPML*
Motor constant
to to
(L coil)
SP384 BSDL*
Parameters with an asterisk * in the abbreviation, such as OSP*, are validated with the NC power turned ON again.
3. Setup
Details
Set the output data number for channel 2 of the D/A
output function.
When set to "0", the output is speedometer.
Set the data magnification for channel 1 of the D/A output
function.
The output magnification is the setting value divided by
256.
When set to "0", the output magnification becomes 1-fold,
in the same manner as when "256" is set.
Set the data magnification for channel 2 of the D/A output
function.
The output magnification is the setting value divided by
256.
When set to "0", the output magnification becomes 1-fold,
in the same manner as when "256" is set.
This parameter is valid only in the following two
conditional cases:
(a) In case that SP034 (SFNC2) bit0=1
and SP034 (SFNC2) bit2=0
Set the motor constants when using a special motor,
not described in the SP040 (MTYP) explanation and
when not using the coil changeover motor.
(b) In case that SP034 (SFNC2) bit0=1
and SP034 (SFNC2) bit2=1
Set the motor constant of the H coil of the coil
changeover motor.
(Note) It is not allowed for the user to change the setting.
This parameter is valid only in the following conditional
case:
(a) In case that SP034 (SFNC2) bit0=1
and SP034 (SFNC2) bit2=1
Set the motor constant of the L coil of the coil
changeover motor.
(Note) It is not allowed for the user to change the setting.
3 - 84
Setting range
(Unit)
-32768 to
32767
-32768 to
32767
(1/256-fold)
-32768 to
32767
(1/256-fold)
0000 to FFFF
(HEX setting)
0000 to FFFF
(HEX setting)
Standard
setting
0
0
0
0000
0000