Mitsubishi MELDAS MDS-C1 Instruction Manual page 85

(2) Detector type related parameters
High-gain specifications
No. Abbrev. Parameter name
SV025 MTYP* Motor/Detector type
Parameters with an asterisk * in the abbreviation, such as PC1*, are validated with the NC power turned ON again.
3. Setup
bit
8
Set the detector type.
9 Set the position detector type for "pen", and the speed detector type
ent
for "ent". In the case of the semi-closed loop control, set the same
A
value for "pen" and "ent".
B
pen
C
ent setting
setting
D
0 0
pen
E
1 1
F
2 2
3 3
4 Setting impossible OHE25K-ET, OSE104-ET
5 Setting impossible OHA25K-ET, OSA104-ET
6 Setting impossible
7 Setting impossible
8 Setting impossible
9 Setting impossible
A Setting impossible
B Setting impossible
C
(Current
C
synchronization)
E
(Current
D
synchronization)
E Setting impossible
F Setting impossible
3 - 6
Explanation
Explanation
Detector model name
OSE104
OSA104
OSE105, OSA105
OSE105-ET, OSA105-ET, RCN723
(Heidenhain)
Relative position detection scale, MP type
(Mitsubishi Heavy Industries)
AT41 (Mitsutoyo), FME type, FLE type
(Futaba)
AT342, AT343, (Mitsutoyo),
LC191M/491M (Heidenhain), MDS-B-HR
The setting of the slave axis in the speed/current
synchronization control.
When the master axis is the semi-closed control.
The setting of the slave axis in the speed/ current
synchronization control.
When the master axis is the full-closed control.
(Current synchronization control is only for
MDS-C1-V2.)