Table 16; Step Task; Configure The T3 Controller; Configure The Serial Interface That Is - Cisco ASR 9000 Series Configuration Manual

Information About Configuring Serial Interfaces
High-Level Overview: Serial Interface Configuration on Channelized SPAs
Table 16Table 17
on the following SPAs and line cards.
•
•
•
•
•

Table 16

Overview: Configuring a Serial Interface on a T1 DS0 Channel
Step Task
1.

Configure the T3 controller

parameters and set the SPA mode to
be T3.
28 T1 controllers are automatically
created.
2. Create and configure DS0 channel
groups on the T1 controllers.
3. Configure the Serial interfaces that
are associated channel groups you
created in Step 2.
Table 17 Overview: Configuring a Serial Interface on a T1 DS0 Channel
Step Task
1. Configure the SONET controller
parameters and STS stream for T3
mode.
2. Configure the T3 controller
parameters and set the mode to T1.
28 T1 controllers are automatically
created.
3. Create and configure DS0 channel
groups on the T1 controllers.
4. Configure the Serial interfaces that
are associated channel groups you
created in Step 2.
Cisco ASR 9000 Aggregation Services Router Interfaces and Hardware Component Configuration Guide
504
provides a high-level overview of the tasks required to configure a T1 serial interface
Cisco 2-Port and 4-Port Channelized T3 SPA
Cisco 4-Port Channelized OC-12/DS3 line cards
Cisco 1-Port Channelized OC-12/DS0 SPAs and line cards
Cisco 1-Port Channelized OC-48/STM-16 SPA and line cards
Cisco 2-Port Channelized OC-12c/DS0 SPA
Module
"Configuring Clear Channel
T3/E3 and Channelized T3 and
T1/E1 Controllers on the
Cisco ASR 9000 Series Router"
"Configuring Clear Channel
T3/E3 and Channelized T3 and
T1/E1 Controllers on the
Cisco ASR 9000 Series Router"
"Configuring Serial Interfaces on
the
Cisco ASR 9000 Series Router"
Module
"Configuring Channelized
SONET/SDH on the
Cisco ASR 9000 Series Router"
"Configuring Clear Channel
T3/E3 and Channelized T3 and
T1/E1 Controllers on the
Cisco ASR 9000 Series Router"
"Configuring Clear Channel
T3/E3 and Channelized T3 and
T1/E1 Controllers on the
Cisco ASR 9000 Series Router"
"Configuring Serial Interfaces on
the
Cisco ASR 9000 Series Router"
Configuring Serial Interfaces on the Cisco ASR 9000 Series Router
Section
Setting the Card Type
Configuring a Channelized T3
Controller
Configuring a T1 Controller
How to Configure Serial Interfaces
Section
Configuring SONET T3 and
VT1.5-Mapped T1 Channels
Configuring a Channelized T3
Controller
Configuring a T1 Controller
How to Configure Serial Interfaces
OL-26061-03