Figure 206. Front video connector assembly removal
Replacing the front video connector assembly
Use this information to replace the front video connector assembly.
To install the front video connector assembly, complete the following steps:
Step 1.
Read the safety information that begins on "Safety" on page v and "Installation guidelines" on page
31.
Step 2.
Turn off the server and peripheral devices and disconnect the power cords and all external cables,
if necessary.
Step 3.
Insert the front video connector assembly into the holes on the chassis.
Figure 207. Front video connector assembly installation
Step 4.
Reinstall the video connector assembly screws.
Figure 208. Video connector assembly screws installation
Step 5.
Reconnect the front video cable to the front video connector on the system board.
280
Lenovo System x3550 M4 Installation and Service Guide