Step 5.
Pull the front video connector assembly out slightly until it disengages from the chassis and set it
aside.
Figure 206. Front video connector assembly removal
Replacing the front video connector assembly
Use this information to replace the front video connector assembly.
To install the front video connector assembly, complete the following steps:
Step 1.
Read the safety information that begins on "Safety" on page v and "Installation guidelines"
on page 31.
Step 2.
Turn off the server and peripheral devices and disconnect the power cords and all external cables,
if necessary.
Step 3.
Insert the front video connector assembly into the holes on the chassis.
Figure 207. Front video connector assembly installation
Step 4.
Reinstall the video connector assembly screws.
.
Chapter 6
Removing and replacing components
281