7
Configuring CPU/LAN or LAN board parameters
Configuring CPU/LAN or LAN board parameters
62
You must configure the CPU/LAN or LAN Board in order to change the global
configuration of a single DTC.
When configuring the CPU/LAN or LAN Board, you can change the following
parameters for the specified DTCs:
•
LAN addresses which include:
•
DTC IP address
•
DTC node name
•
Global parameters which include:
•
event logging classes
•
DTC user interface timeout
•
DTC user prompt
•
DTC user welcome message
•
Enable DTCDF access
•
DTCDF password
•
TCP parameters which are TCP timers that may need to be altered for extended
LAN configurations
•
DNS/IP parameters which include:
•
default DNS (domain name server) and backups
•
default IP router addresses and backups
•
SNMP authorization filters which include:
•
your network's SNMP management nodes, the information that these nodes
can request and the rights of access to the SNMP MIB data
•
SNMP/MIB data parameters which include:
•
the SNMP-specific data to be stored on the DTC
•
DTC management protocol parameters which include:
•
the DTC management protocol parameters that may need to be altered for
traffic over LANs with bridges