Object Parameter - HP 9000 Series 700 Manual

-l loglevel Specifies the amount of information that is logged in the log file for this dtcdiag
execution. The default logfile is
one of the following logging levels:
0
1
2
Specifies an alternative file that dtcdiag should use to log status and error messages.
-L logfile
The default log file is

Object parameter

Specify the
specified:
dtcs The names of the DTCs on which a task is to be performed.
A DTC name must be specified. The asterisk metacharacter (*) can be used to
represent any string of characters for this parameter and it normally needs to be
escaped. For example, if the DTC names are
parameter can be
If this parameter is given without boards or ports, then the action with boards
specified as
Caution If the DTC name is
This occurs because these names are also used as the label for the CPU/LAN board
of a DTC 48 or a DTC 16 (
and the ports of a DTC 16TN (
of a DTC is
line will be understood as that DTC name.
The name of the DTC boards on which the task is done.
boards
This parameter is optional. Board names are:
C or c
L or l
Log only startup and termination messages.
Log serious or fatal error messages (and those of level 0). This is the default.
Log warning and informational messages (plus the messages of level 1).
/var/opt/dtcmgr/log/dtcdiag.log
to be diagnosed with these parameters given in the order
object
to mean all those DTCs.
DTC\*
or is taken.
C L
, , or , a conflict may occur when specifying many objects.
C L B
), the LAN board of a DTC 72MX or a DTC 16TN (
C
B
, , or , then any such character found in the object of the command
C L B
the CPU/LAN on a DTC 48 or DTC 16
the LAN on a DTC 72MX or DTC 16TN
Other dtcdiag parameter definitions
/var/opt/dtcmgr/log/dtcdiag.log
, and
DTC1 DTC2
), respectively. To resolve this conflict, if the name
. Specify
.
, the
DTC3 dtcs
),
L
159
13