Before Installing Dtc Manager/Ux; Hardware Requirements - HP 9000 Series 700 Manual

Before installing DTC Manager/UX

This chapter describes requirements that must be satisfied before DTC Manager/UX
can be installed.
Even though the product supports up to 4 LAN devices, it is recommended that all
LAN devices be located on a single LAN,
procedure), and that DTC Manager/UX be located on this same LAN. DTC
Manager/UX is, however, compatible with other LAN devices that are connected to
the LAN by means of a bridge or hub.
Note DTC Manager/UX does not provide support for router-connected devices.

Hardware requirements

Ensure that you have the following:
•
•
•
•
•
1
an HP 9000 Series 700 or 800
LAN/9000 LINK hardware components including a minimum of one LAN
interface card (LANIC) and up to 4 LAN devices
for an 800 system, a terminal connected to a MUX
at least 20 Mbytes of free disk space for the DTC Manager/UX software
additional disk space depending on the number of DTCs, the DTC types, and the
space you need for upload files
The upload files are located in the /
can save up to three upload files from each DTC. When three upload files have
been saved, DTC Manager/UX overwrites the first one again. The disk space
needed is:
• 1 Mbyte for each upload file from a DTC 16 or DTC 48
• 3 Mbytes for each upload file from a DTC 16TN
• 5 Mbytes for each upload file from a DTC 72MX
Only upload DTC files if instructed to do so by an HP engineer.
(to facilitate the installation
lan0
1
during troubleshooting
var/opt/dtcmgr/upload
2
directory. You
23