Table of Contents
Advertisement
9 Verify that the ocd process has been started by looking at the output of the
10 Enable the DDFA variable in the
Configuring a DTC printer for the HP-UX spooler
The DTC printer must be configured for the HP-UX spooler using SAM (System
Administration Manager) or the HP-UX lpadmin command. Refer to the HP-UX
System Administration Tasks Manual for information on the HP-UX printer spooler.
Configuring a printer with SAM
To configure the HP-UX spooler from SAM, follow these steps. They are for an
HP-UX 9.x system on an HP 9000 Series 800 system. The procedure may vary
slightly for different versions of HP-UX.
1 Select the following menu options (starting from the SAM main menu).
2 Complete the Add Printer screen as follows:
3 Complete the other fields as required and exit from SAM.
following command:
ps -ef |grep ocd
ensure that the ocd processes are started correctly each time the system is started.
a
Choose Printers/Plotters.
b In the Printer/Plotter Manager screen, choose:
Actions
Local Printer Plotter
If you are using a character mode terminal, the menubar (F4 Menubar On/
Off) must be on to use the Actions menu.
c
Choose Add Printer/Plotter Requiring Nonstandard Device File.
:
Printer Name
Assign a name to the printer.
:
Printer Model/Interface
the printer model corresponding to your printer from the list of printer models
displayed.
Printer Device File Name
file
for the DTC printer port. For the device file name in the
/etc/ddfa/dp
example on page 108 you would enter:
/dev/telnet/dtc1b3p2
Configuring a DTC to enable a printer
/etc/rc.config.d/netdaemons
With this field selected, press the Enter key. Choose
:
Enter the printer device file that you entered in the
8
file to
109
Advertisement
Table of Contents
