Checking The Dtc Download - HP 9000 Series 700 Manual

15

Checking the DTC download

Checking the DTC download
178
If the power-on self-test is successful, the DTC broadcasts a boot request on the
LAN, and waits for a host running DTC Manager/UX software to download it. The
HP 9000 which on which the DTC was configured receives and responds to the boot
request. The DTC is ready only after the download operation is successful.
The following steps describe how to ensure that the DTC configuration is
downloaded from the DTC Manager/UX to the DTC.
1 Use the summary of the display codes and their meanings (located either inside
the front cover of the DTC or underneath on a pull-out card) to interpret the
front-panel display, or refer to the DTC hardware manual for a more detailed
explanation of the codes displayed on the DTC.
2 If the display code indicates a successful download, go to "Checking that the
Internet Services software is operational".
3 If the display code does not indicate a successful download, and you suspect that
you may have a DTC 48 without a memory extension, take the following steps:
a Look in the
rbootd
message:
Dropped packet: need memory extension card <type of
current hardware>
b If you need a memory extension card for your DTC 48, contact your
Hewlett-Packard representative.
4 If the display code does not indicate a successful download, use the Modify DTC
Configuration option in dtcconfig to correct the configuration information. If
this DTC is not included in the list of configured DTCs, it is probably because the
DTC LAN address is incorrectly configured in the DTC Manager/UX. Delete the
DTC and add it again, taking care to enter the DTC LAN address exactly as it is
marked on the DTC.
5 Try to download the DTC again.
6 If the display code does not indicate a successful download, go to the next stage
of the troubleshooting.
log file,
/var/adm/rbootd.log
, for the following