Table of Contents
Advertisement
6
Using the Rear Panel Configuration screen
Note
Using the Rear Panel Configuration screen
56
There are two ways to reset the DTC and start the download:
•
turn the DTC off and then on
or
•
run the command dtcreset
You must reset the DTC after modifications to save your changes. Do not use the
Modify DTC Configuration option on this DTC again until you have reset the DTC.
Otherwise you may lose the changes you have just made.
The Rear Panel Configuration screen represents the rear of the DTC and is the
starting point for all DTC configuration procedures.
The Rear Panel Configuration screen allows you to perform the following tasks:
•
Configure global DTC parameters on the CPU/LAN or LAN board
•
Configure ports on a particular board (see "Configuring terminal and printer
ports" on page 87).
•
Copy a board within a DTC or to another DTC (see "Copying and pasting a board
or port" on page 120).
•
The Rear Panel Configuration screen for each type of DTC is shown on the
following pages.
1 Select Modify DTC Configuration from the main menu of the dtcconfig utility.
2 A pop-up window asks you for the name of the DTC whose configuration you
want to modify.
•
Type in a DTC name
or
•
Press the Help (F1) function key to see the list of existing DTCs. Highlight
the DTC on the list you want to modify and press Return or the Select Item
(F4) function key.
The DTC Rear Panel Configuration screen appears.
.
dtcname
Advertisement
Table of Contents
