Connecting Devices On The Scsi/Lan Combination Board - HP Kayak XA 05xx Manual

Connecting Devices on the SCSI/LAN Combination Board

The SCSI/LAN Combination Board includes two SCSI connectors:
an Internal Wide and an Internal Narrow. Can I connect devices to
both these connectors at the same time?
No, you cannot. Connecting devices to both these devices at
the same time will result in a badly "terminated" SCSI bus.
For HP Kayak XA Series 0503 and 0541 PC Workstations supplied with a
SCSI / 10BT/100TX LAN combination board, only an Internal Narrow SCSI
cable is provided.
The following diagram shows the SCSI/LAN Combo board connectors.
Thirteen-pin connector (J4)
to connect the ExtStart
cable to the system board.
LAN Controller
Optional Boot Rom
Socket (option)
External Wide SCSI
connector (J7).
LED which indicates LAN link
RJ-45 connector.
Connecting Devices on the SCSI/LAN Combination Board
Three-pin connector (J8)
to connect the WOL cable
to the system board.
PCI connector.
Internal Wide SCSI
connector (J3 - not used).
Internal Narrow SCSI
connector (J9 - used).
Flash memory (128 KB)
Symbios Logic
(53C875JE)
PCI-to-PCI Bridge
27