Preparing The Environment For The Required Daemon Processes - HP 9000 Series 700 Manual

3 Installing DTC Manager/UX with HP-UX 10.x

Preparing the environment for the required daemon processes

Note
Note
28
Before you can run DTC Manager/UX, you must configure certain parameters in the
/etc/rc.config.d/netdaemons
required daemons will be started automatically when your system is rebooted.
Checking the name of LAN device file
1 Execute the lanscan command to display the list of physically connected LAN
devices on your system.
2 Look for the Net-Interface Name defined in the information displayed by
lanscan. Identify the LAN device file name that corresponds to the LAN on
which your DTCs are connected (
Configuring the netdaemons configuration file
The
/etc/rc.config.d/netdaemons
Internet Services.
1 Open the
netdaemons
go to the following lines:
export START_RBOOTD=0
export RBOOTD_DEVICES=
To make the daemon start automatically when the system is booted,
rbootd
ensure that the value at the end of the
below.
export START_RBOOTD=1
No space is allowed after the equal (
2 Verify that all LAN devices connected to the DTC(s) are declared in the
line.
RBOOTD_DEVICES
The DTC Manager supports up to four LAN devices.
Enter the full path name of each LAN device (separate each device name with a
space) as shown below:
Version 10.00/10.01/10.10/10.20
export RBOOTD_DEVICES="/dev/lan0 /dev/lan1 /dev/lan3"
From Version 10.30
export RBOOTD_DEVICES="lan0 lan1 lan3"
file. This is necessary to ensure that the
, for example).
lan0
configuration file contains data related to
configuration file with your text editor (or use ch_rc) and
START_RBOOTD
) sign.
=
line is set to as shown
1