Procedure; Details Of Each Function - Konica Minolta BIZHUB C3100P Service Manual

19
20
21 Choice of prohibiting environment
measurement on sleep mode
22 Choice 2 of not executing image
stabilization
23 Not used
24
25 Choice of 1200dpi line width
26 Not used
27
28 Choice of toner empty recovery mode

3.15.2 Procedure

1. Call [SERVICE MODE] to the display.
2. Select [ENGINE DIPSW] and press the Menu/Select key.
3. Select the Change switch by using the up key/down key, and press the Menu/Select key.
4. Change the setting by using the up key/down key, and press the Menu/Select key.

3.15.3 Details of Each Function

(1) Change of developing unit cleaning frequency
• Increase the cleaning frequency of the developing unit.
• To be performed when remarkable stain is found due to insufficient cleaning.
• 0: OFF (default)
• 1: ON
(2) Choice of not executing image stabilization
• Decrease the frequency of image stabilization.
• 0: Normal frequency of image stabilization (default)
• 1: Decrease frequency of image stabilization
(3) Choice of prohibiting environment measurement on sleep mode
• Noise control
• To set whether or not to check the environment in the sleep mode.
• When 0 (Execute) is selected, once start the machine to check the environment when one hour elapsed.
• 0: Execute environment measurement (default)
• 1: Not to execute environment measurement
(4) Choice 2 of not executing image stabilization
• Decrease frequency of image stabilization.
• A limitation stricter than SW No.14 has been set in the image stabilization execution condition.
• 0: Normal frequency of image stabilization (default)
• 1: Decrease frequency of image stabilization (Decrease frequency of image stabilization furthermore to make the limitation looser than
switch No.14.)
(5) Choice of 1200 dpi line width
• To make line width of 1200 dpi broader.
• 0: Priority on density (default)
• 1: Priority on making characters thinner
(6) Choice of toner empty recovery mode
• By executing this function, the New release of a toner cartridge can be executed forcibly when a new toner cartridge is not detected for
some reason.
• 0: Not to execute (default)
• 1: Execute
NOTE
• Be sure to set back to "0" after release an empty status.
I.3.15.3.(3) Choice of prohibiting environment measurement on sleep mode
I.3.15.3.(4) Choice 2 of not executing image stabilization
I.3.15.3.(5) Choice of 1200 dpi line width
I.3.15.3.(6) Choice of toner empty recovery mode
I-23
I ADJUSTMENT/SETTING > 3. SERVICE MODE
-
-
-
-
-
-