Konica Minolta BIZHUB C3100P Service Manual page 100

[1]
[1]
[2]
[2]
[2]
[1]
[3] [1]
[1]
[2]
23. To reinstall, reverse the order of removal.
[4]
[2]
G DISASSEMBLING/REASSEMBLING > 5. Disassembly/reassembly
17. Remove the harness from three wire saddles [1].
18. Remove three screws [1], and remove the metal plate [2] with the
protective sheet attached.
19. Disconnect the connector [1].
20. Remove two screws [2].
21. Remove the E-ring [1] and bushing [2], and remove the holder [3].
NOTE
• Before removing the holder [3], attach tape or similar
material [4] to the section shown in the illustration to
prevent the shaft from falling down and being lost.
22. Remove the gear [1], and remove the loop detection clutch [2].
G-27
procedure (b...