Loadable Download; Use; Required Systems; Writing Data To Usb Memory Device - Konica Minolta BIZHUB C3100P Service Manual

3.13 LOADABLE DOWNLOAD

3.13.1 Use

• Download the loadable driver data in the machine.
• Use a USB memory for the downloading.

3.13.2 Required systems

• PC having a USB port
• USB memory device

3.13.3 Writing data to USB memory device

1. Save the loadable driver data in an appropriate location of the PC.
2. Connect the USB memory device to the PC.
3. Create a [firmware] folder in an area immediately under the drive of the USB memory device.
4. Copy the loadable driver data (***.tar) in the firmware folder created in step 3.
NOTE
• Make sure that the loadable driver data is saved in drive:/firmware/***.tar.

3.13.4 Procedure

1. Turn ON the main power switch and connect the USB memory device to the USB port of the machine.
2. Call [SERVICE MODE] to the display
3. Select [LOADABLE DOWNLOAD].
4. The loadable driver data in the USB memory device is displayed in a list.
5. Select the loadable driver data to be downloaded and press the Menu/Select key.
6. Select the [YES] and press the Menu/Select key.
7. The loadable driver starts to be downloaded.
NOTE
• NEVER disconnect the USB memory device from the machine while the loadable driver is being downloaded.
8. Following the messages shown on the control panel, restart the machine.

3.14 HDD FORMAT

3.14.1 Use
• To format the hard disk.
3.14.2 Procedure
• Press the Menu/Select key.

3.15 ENGINE DIPSW

It will be displayed when the following setting shows that switch No.59 is set to [1].
[SERVICE MODE] -> [SYSTEM 2] -> [SOFT SWITCH]
3.15.1 Use
• To make printer engine settings.
• The following table shows DIP switches that can be set in this machine.
Switch No.
1 Not used
2
3
4
5
6
7
8
9
10
11
12 Change of developing unit cleaning
frequency
13 Not used
14 Choice of not executing image
stabilization
15 Not used
16
17
18
and press the Menu/Select key.
Function
I.3.15.3.(1) Change of developing unit cleaning frequency
I.3.15.3.(2) Choice of not executing image stabilization
I ADJUSTMENT/SETTING > 3. SERVICE MODE
Ref. page
I-22
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-